timeout - run a command with a time limit

timeout [OPTION] DURATION COMMAND [ARG]...
timeout [OPTION]

Start COMMAND, and kill it if still running after DURATION.

Mandatory arguments to long options are mandatory for short options too.

--preserve-status

exit with the same status as COMMAND, even when the

command times out

--foreground

when not running timeout directly from a shell prompt,

allow COMMAND to read from the TTY and get TTY signals; in this mode, children of COMMAND will not be timed out

-k, --kill-after=DURATION

also send a KILL signal if COMMAND is still running

this long after the initial signal was sent

-s, --signal=SIGNAL

specify the signal to be sent on timeout;

SIGNAL may be a name like 'HUP' or a number; see 'kill -l' for a list of signals

-v, --verbose

diagnose to stderr any signal sent upon timeout

--help

display this help and exit

--version

output version information and exit

DURATION is a floating point number with an optional suffix: 's' for seconds (the default), 'm' for minutes, 'h' for hours or 'd' for days. A duration of 0 disables the associated timeout.

Upon timeout, send the TERM signal to COMMAND, if no other SIGNAL specified. The TERM signal kills any process that does not block or catch that signal. It may be necessary to use the KILL signal, since this signal can't be caught.

Exit status:

124

if COMMAND times out, and --preserve-status is not specified

125

if the timeout command itself fails

126

if COMMAND is found but cannot be invoked

127

if COMMAND cannot be found

137

if COMMAND (or timeout itself) is sent the KILL (9) signal (128+9)

-

the exit status of COMMAND otherwise

kill(1)

Full documentation <https://www.gnu.org/software/coreutils/timeout>
or available locally via: info '(coreutils) timeout invocation'