setfsgid - set group identity used for filesystem checks
On Linux, a process has both a filesystem group ID and an effective group ID. The (Linux-specific) filesystem group ID is used for permissions checking when accessing filesystem objects, while the effective group ID is used for some other kinds of permissions checks (see credentials(7)).
Normally, the value of the process's filesystem group ID is the same
as the value of its effective group ID. This is so, because whenever a
process's effective group ID is changed, the kernel also changes the
filesystem group ID to be the same as the new value of the effective
group ID. A process can cause the value of its filesystem group ID to
diverge from its effective group ID by using setfsgid()
to change its filesystem group ID to the value given in
setfsgid() will succeed only if the caller is the
superuser or if
fsgid matches either the caller's real group
ID, effective group ID, saved set-group-ID, or current the filesystem
On both success and failure, this call returns the previous filesystem group ID of the caller.
This system call is present in Linux since version 1.2.
The filesystem group ID concept and the setfsgid() system call were invented for historical reasons that are no longer applicable on modern Linux kernels. See setfsuid(2) for a discussion of why the use of both setfsuid(2) and setfsgid() is nowadays unneeded.
The original Linux setfsgid() system call supported only 16-bit group IDs. Subsequently, Linux 2.4 added setfsgid32() supporting 32-bit IDs. The glibc setfsgid() wrapper function transparently deals with the variation across kernel versions.
In glibc 2.15 and earlier, when the wrapper for this system call
determines that the argument can't be passed to the kernel without
integer truncation (because the kernel is old and does not support
32-bit group IDs), it will return -1 and set
EINVAL without attempting the system call.
No error indications of any kind are returned to the caller, and the
fact that both successful and unsuccessful calls return the same value
makes it impossible to directly determine whether the call succeeded or
failed. Instead, the caller must resort to looking at the return value
from a further call such as
setfsgid(-1) (which will always
fail), in order to determine if a preceding call to
setfsgid() changed the filesystem group ID. At the very
least, EPERM should be returned when the call fails
(because the caller lacks the CAP_SETGID
This page is part of release 5.10 of the Linux
project. A description of the project, information about reporting bugs,
and the latest version of this page, can be found at